How to start an automatic car without a battery

Posted on

How to start an automatic car without a battery


Automatic vehicles offer easier and more practical driving for many people. But, it is important to know some mechanical failures that can suddenly occur in automatic vehicles. In this case, we refer specifically to How to start an automatic car without a battery. There are several ways and methods to use in case it occurs. Here we offer them to you.

How to start an automatic car without a battery
How to start an automatic car without a battery

How to start an automatic car with a dead battery

Until now, there are 4 ways that are not cumbersome at all that allow you to start a car without a battery, we are going to know each of the options:

1. Use a portable battery charger to charge the battery

How to start an automatic car without a battery
How to start an automatic car without a battery

It turns out the more practical and economical solution, if you have a portable battery chargerwhat you should do is charge the battery of the automatic car to start, you only have to follow these steps:

  1. You must connect the charger to the battery. The charger has its cables, connect the positive clamp to the positive side and the negative to the opposite end of the battery.
  2. Configure the charger. You have to choose how you want to send power to the battery: you can choose to increase the power or introduce it gradually. The gradual input of energy ensures that the battery charge lasts longer.
  3. Start the loader. Once the charging type is set, turn on the charger and let it run. Almost all autoloaders go into off mode automatically.
  4. Disconnect the charger and start the car.
  5. In case the car does not start, you may need to charge the battery a little longer. Try charging it for half an hour and start the car again.

2. Jump start car battery

How to start an automatic car without a battery
How to start an automatic car without a battery

Many drivers do not have a charged battery on their trips, so the most common way to restart the automatic car is to start the drums, the discharged battery should be connected to another battery using the jumper cables. Jump starting means that it will operate with currents, it is important to follow the steps to jump start the car safely. These are simply the steps to start the automatic car.

  • Locate the proper jumper wires

Jumper cables are used to transfer power from a good battery to a dead battery.. An essential tool that you should always keep in your vehicle is a high quality jumper cable set, especially electrical cables and they have alligator clips that connect two batteries.


  • Find a charged battery

To run the dead battery, you must have a good battery on hand and of the same voltage as the dead battery. Then park the running car parallel to the other car, turn off the engine before connecting the jumper cables.

  • Connect jumper cables to both batteries

For To identify the positive terminal, you must locate the plus sign (+) or the word “POS”. You should now connect one of the red alligator clips to the positive terminal of the discharged battery. Connect the other red alligator clip to the positive side of the other car’s battery. The black alligator clip should be connected to the negative terminal of the other car’s battery. The negative terminal can have an “OV” or “GND” sign. Proceed to attach the black clip to a bare metal strip.

  • start cars

Must start the car with the battery running, and let the engine run for a few minutes. Then you should try to start the automatic car. In case the auto car still won’t start, please let the active car run for additional time.

  • Drive the car

When you notice the car start to run, you should drive it for at least a kilometer, in order to make sure that the battery has enough charge. keep in mind, If the battery is about to expire, the car may not start, even after turning it on.which means that the battery must be replaced with a new one.

3. Change the car battery

How to start an automatic car without a battery
How to start an automatic car without a battery

If the charging and starting of the battery does not work, it is best to replace the part. The process of changing the battery is very practical and technical, but if you don’t know how to do it, it is best to take the vehicle to an expert workshop, before risking making a mistake.

Steps to change the battery

  1. Wear heavy gloves to protect yourself from any current if you come into contact with an exposed wire.
  2. You need to make sure you have the correct replacement battery. Important, the replacement battery must have the same size and voltage of the battery to be changed.
  3. The car engine should be turned off.
  4. Disconnect and remove the old battery from the battery terminal
  5. Clean the inside of the battery slot with a clean cloth
  6. Place the new battery in the battery maintenance slot in an upright position.
  7. Reinstall the battery restraints to secure them in place.
  8. Connect the terminal cables from one battery to the other so that the positive and negative cables match up with the negative and positive sides of the battery.
  9. Start the car and drive it for 15 minutes to make sure the new battery works well.

Symptoms that indicate the battery needs replacement

  • The car won’t start
  • It takes a while for the engine to warm up.
  • Car lights are dim even at maximum level
  • Continuous smell of gasoline in the car
  • Leaky battery or this worn out
  • The battery box looks damaged.

Car batteries have an approximate useful life between 3-5 years, so it is necessary to replace them. Even if the battery shows no signs of wear, it’s best to replace it if it has reached five years or more.

4. Contact a roadside assistance company or towing service

If you do not have adequate equipment at the moment, it is also difficult for you to start the car with the aforementioned methods, then you should call the roadside assistance service, they will offer you different types of help such as:

  • Towing the car, if necessary, you can tow the vehicle to a place where you can easily find a replacement battery.
  • They can check the car, possibly you will discover that it is not due to the discharged battery that generates the failure.
  • They can offer a quick start, or charge the battery with a laptop

Can auto auto start by pushing it?

How to start an automatic car without a battery
How to start an automatic car without a battery

Automatic cars do not enjoy this goodness, only cars with manual transmission. All because the clutch and motor of an automatic car need a battery in good condition to work. If an automatic car’s battery is dead, the only way it will start is to replace the battery.

Battery chargers and jumper cables


Having a battery charger and jumper cables is something that will never make you look bad. You can get these types of tools at any vehicle accessory and spare parts store.


Summary

There are several ways to start an automatic car with a dead battery, including starting, charging or changing the battery. In the event that none of these alternatives work well, or if you do not have the necessary equipment on hand, then you should contact roadside assistance.

Writing Gossipvehicle